Table of Contents
Advertisement
Installation and operation
Setting Speed
1. Use the speed controller to select one of the settings.
Selection of speed level (1–10) depends mostly on type, amount, and consistence
of ingredients to be processed.
Observe the recommended speed settings in Table 1.
NOTE!
Always start from the lowest speed setting and gradually select higher
levels until reaching the required speed.
Processing of Ingredients
1. Press Start button (green) in order to start the processing.
2. Process the required ingredients.
3. If subsequent ingredients are to be added during operation, stop the appliance
by pressing the Stop/OFF button (red).
4. Add the required ingredients.
5. Continue processing by pressing the Start button (green).
6. When the processing of food products is finished, rotate the speed controller to
'0' setting.
ATTENTION!
In case of drive overload during operation, stop the appliance by pressing
the Stop/OFF button (red) and immediately reduce the mixing bowl filling.
Switching the Appliance Off / Removing the Mixing Bowl
1. Press the Stop/OFF button (red), to switch the appliance on.
2. Rotate the opening/closing lever upwards.
3. Raise the motor block upwards.
4. Remove mixing elements by pressing them slightly towards the holder chuck,
rotating counter-clockwise, and then pulling down.
5. Put mixing elements in the mixing bowl.
6. Remove the mixing bowl with mixing elements from the hollow by rotating it,
pulling out of fixing catches and raising.
7. Remove mixing elements.
8. If needed, put the processed food products into a suitable container.
101915
EN
15 / 18
Advertisement
Table of Contents
