Checking Before Installation; Checking The Installation Space; Check Items When Turning Off The Main Power; Points To Note At Installation - Canon Inner Finisher-J1 Service Manual

Checking Before Installation

Checking the Installation Space

The minimum space shown in the figure is required for installation and maintenance.

Check Items when Turning OFF the Main Power

Check that the main power switch is OFF.
1. Turn OFF the main power switch of the Host Machine.
2. Be sure that control panel display and main power lamp are both turned OFF, and then disconnect the power plug from the
outlet.

Points to Note at Installation

• This installation procedure is written only about the installation of the inner finisher. When installing the inner puncher unit
together with the finisher, refer to the installation procedure supplied with the inner puncher unit instead of referring this
installation procedure.
• Marked portion
When tightening the screws, do not tighten them too tightly. Otherwise, there is a risk of damage and deformation of screw
holes.

Kontrollen vor der Installation (German/Deutsch)

■ Vorsichtshinweise zur Installation
Unterbrechen der Netzversorgung
1. Schalten Sie den Netzschalter der Hostmaschine aus.
2. Überzeugen Sie sich zunächst, dass sowohl das Display auf dem Bedienfeld als auch die Netzstrom-Kontrolleuchte
erloschen sind, und ziehen Sie dann den Netzstecker.

Product Name

Safety regulations require the product's name to be registered. In some regions where this product is sold, the following names
may be registered instead.
F281123
100 mm or more
500 mm or more
79
6. Installation