Table of Contents
Advertisement
Warning
Danger of accidents Brake linings which have not been approved alter the braking efficiency.
Not all brake linings are tested and approved for GASGAS motorcycles. The structure and friction coefficient of the
brake linings, and thus their brake power, may vary greatly from that of original brake linings.
If brake linings are used that differ from the original equipment, compliance with the original homologation is
not guaranteed. In this case, the vehicle no longer corresponds to its condition at delivery and the manufacturer
warranty shall be void.
–
Only use brake linings approved and recommended by GASGAS Motorcycles.
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the appli-
cable regulations.
Info
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and brake lines are not designed for
DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid corrodes paint.
Only use clean brake fluid from a sealed container.
–
Stand the vehicle upright.
–
Remove screw cap
A00835-10
–
Manually press the brake caliper toward the brake disc to push back
the brake piston. Ensure that brake fluid does not flow out of the
brake fluid reservoir; extract some if necessary.
Info
Make sure that you do not press the brake caliper against
the spokes when pushing back the brake piston.
–
Remove cotter pins
ings.
J00084-10
–
Clean the brake caliper and the brake caliper bracket.
–
Check that spring plate
6
ing plate
in the brake caliper bracket are seated correctly.
Info
The arrow on the spring plate points in the direction of rota-
tion of the brake disc.
J00085-10
1
2
with membrane
and the O-ring.
3
4
, pull out pin
, and remove the brake lin-
5
in the brake caliper and brake pad slid-
BRAKE SYSTEM 12
87
Advertisement
Table of Contents
