–
Position oil screen
–
Position the pin wrench through the drill hole of the screw plug in
the opposite section of the engine case.
–
Push the oil screen all the way into the engine case.
G05105-10
–
Mount and tighten screw plug
Guideline
Screw plug, oil screen
–
Mount and tighten oil drain plug
seal ring.
Guideline
Oil drain plug with
magnet
E01243-10
–
Remove screws
G05091-10
–
6
Pull oil filter
Lock ring plier (51012011000)
–
Allow the engine oil to drain completely.
–
Thoroughly clean the parts and the sealing surfaces.
G05092-10
–
Lay the motorcycle on its side and fill the oil filter housing to about
⅓ full with engine oil.
–
Fill the oil filter with engine oil and position the oil filter in the hous-
ing.
–
Oil the O-ring of the oil filter cover and mount it together with oil
7
filter cover
.
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
G05093-10
–
Stand the motorcycle upright.
SERVICE WORK ON THE ENGINE 17
4
with the O-rings on a pin wrench.
3
with the O-ring.
M20x1.5
15 Nm (11.1 lbf ft)
1
with the magnet and a new
M12x1.5
20 Nm (14.8 lbf ft)
5
. Take off the oil filter cover with the O-ring.
out of the oil filter housing.
M6
10 Nm (7.4 lbf ft)
111