Alarms - AgaMatrix Liberty Owner's Booklet

TEMPERATURE MESSAGE
Flashing message, with double beep
(if volume is enabled in SET Options)
MEANING: The test has been performed outside the
operating temperature range.
ACTIONS: Move to an area with an ambient tempera-
ture of 50° F to 104° F (10° C to 40° C). Wait for the
meter and test strips to reach the new temperature
(usually 10-20 minutes) and retest.
LOW BATTERY MESSAGE
Flashing message
MEANING: The battery in your meter is low.
ACTIONS: If the battery symbol appears, the batteries
must be replaced (see Batteries Section beginning on
page 76). If the battery symbol appears, the backlight
will be disabled in all modes.
56 Display Messages
The main steps covered in this section are:
[1] Entering MENU Mode
[2] Entering Alarm Option
[3] Turning Alarms ON or OFF
[4] Setting Alarm Times
[5] Setting Alarm Volumes
[6] Setting Multiple Alarms
There are 6 alarms you can set to remind you when to
test your glucose levels.
When alarms are activated:
If an alarm is set and the Liberty™ Meter is turned OFF,
the alarm will turn the meter ON. "AL1" through "AL6"
(depending on which alarm is set) is displayed. The dis-
play backlight fl ashes, and the meter will beep repeat-
edly for 15 seconds.
You can turn the alarm OFF by pressing any button.
The alarms will not appear during Menu and Test
Modes. If an alarm is set to go off when using these
modes, it will be activated after the meter is turned OFF.

Alarms

Alarms 57