Roland S-1 Owner's Manual page 27

[REVERB] knob
This effect produces reverberation, like being in a hall or room.
1. Turn the [REVERB] knob to adjust the volume of the reverb (r0–r255).
Adjust the reverb length (time) by turning the [REVERB] knob while holding down the [SHIFT] button.
Configuring the reverb (REVERB)
1. Hold down the [SHIFT] button and press pad [14] (REVERB).
2. Use the [TEMPO/VALUE] knob to select a parameter, and then press pad [2] (ENTER).
3. Turn the [TEMPO/VALUE] knob to edit the value.
Parameter Value
ANb, RooN, hAL1, hAL2, PLAt,
SPrn, Nod
tyPE
(Type)
0–255
tiNE
(Time)
0–255
LEv
(Level)
0–100 (ms)
Pr. d L
(Pre
Delay)
FLAt,
20, 25, 31.5, 40, 50, 63, 80, 100, 125,
Lo. C t
(Low Cut) 160, 200, 250, 315, 400, 500, 630, 800
(Hz)
630, 800, 1k, 1.25k, 1.6k, 2k, 2.5k,
Hi. C t
3.15k, 4k, 5k, 6.3k, 8k, 10k, 12.5k (Hz),
(High Cut)
FLAt
0–10
dEnS
(Density)
You can use the "Global Delay/Reverb
parameters or from the system parameters.
Chorus
This effect adds a tiny amount of pitch modulation, creating a more spacious and thicker sound.
1. Hold down the [SHIFT] button and press pad [15] (MENU).
2. Use the [TEMPO/VALUE] knob to select "Cho", and press pad [2] (ENTER).
3. Use the [TEMPO/VALUE] knob to select the chorus type.
Value Explanation
The chorus effect is not applied.
OFF
Explanation
This selects the reverb type.
●
ANb (Ambience): Simulates an ambience mic (off-mic, placed at a
distance from the sound source) used in recording and other
applications.
●
RooN (Room): Simulates the reverberation in a small room.
●
hAL1 (Hall1): Simulates the reverberation in a concert hall. Provides
clear and spacious reverberations.
●
hAL2 (Hall2): Simulates the reverberation in a concert hall. Provides
mild reverberations.
●
PLAt (Plate): Simulates plate reverb (a reverb unit that uses the
vibration of a metallic plate).
●
SPrn (Spring): This simulates the sound of a guitar amp's built-in
spring reverb.
●
Nod (Modulate): A reverb with an added wavering effect for the hall
reverberations.
Adjusts the length (time) of reverberation.
Adjusts the volume of the reverb sound.
Adjusts the time until the reverb sound starts to output.
Cuts the frequencies below the frequency that you set.
No frequencies are cut when this is set to "FLAt ".
Cuts the frequencies above the frequency that you set.
No frequencies are cut when this is set to "FLAt ".
Adjusts the density of the reverb sound.
SW(P.68)" setting to select whether to control the delay and reverb from the pattern
Creating sounds
27