Control/Address Settings - Sanyo VCC-HD5600P Setup Manual

Control/Address Settings

When you connect the camera to a controller, it is necessary to configure the interface board control
switch and address switch.
■
Control switch
This is used to configure transmission rate and protocol, etc.
•
Switches 4 and 5 are not used.
•
Settings in bold typeface in the table below show the factory default
configurations.
❶
Baud Rate
Configure the transmission rate of connected devices to the transmission
rate of the camera.
Transmission Rate
2400
4800
9600
19200
When protocol is set to "PELCO", set to 2400.
❷
Protocol
Select the protocol for controlling the camera.
Protocol
SSP (SANYO)
PELCO
❸
Terminator
When you connect multiple cameras, set the terminator setting (Switch 6) of the final device to "ON"
and all other devices to "OFF".
■
Address switch
When you connect multiple cameras, allocate a unique RS485 protocol address (camera number) to
each camera.
Configure the address by setting the dip switches to "ON" and "OFF".
For further information, refer to the "Address Settings Table" on
the next page.
Switch 1
OFF
ON
OFF
ON
Switch 3
OFF Automatic switching between Sanyo SSP and high speed SSP
ON Automatic switching between PELCO-D and PELCO-P
Switch 2
OFF
OFF
ON
ON
Corresponding Protocol
9
ON ON
1 1 2 3 2 3 4 4
❶ ❷ ❶ ❷
ON
1 2 3 4 5 6 7
5 5 6 6
❸ ❸
8