Name And Function Of Each Component - Sanyo VCC-HD5600P Setup Manual

Name and Function of Each Component

This device is composed of a camera unit and power unit (VA-94S).
③
⑧
① Connection Point
This is the connection point between the camera unit and the power unit.
② Interface Board (accessories)
Control switch (transmission rate and protocol setting, etc.)
Address switch (control camera address setting)
Control terminal (connection of controller and alarm input/output cable)
③ LAN/EX-HDD Terminal
Ⓐ
LAN terminal (RJ-45 type):
Use this socket to connect the camera to your PC to enable network operation.
Ⓑ
EX-HDD terminal (USB type):
When recording live video onto an external hard disk, put the hard disk in a dedicated hard disk
case (VA-HDC4000; sold separately) and then connect the case to the camera.
④ SD Card Slot
When recording live video onto an SD memory card, insert the card into the slot.
⑤ Power terminal
Use this cable to connect a 24 VAC power supply.
There is no power indicator on the camera.
⑥ Audio output terminal (black: 3.5-mm mini jack)
Connect this jack via an audio cable to the audio input jack of an amplified speaker system or the
monitor.
⑦ Audio input terminal (white: 3.5-mm mini jack)
Use this jack to connect an external microphone to listen to the sound while monitoring the live
video, or simultaneously record the video and sound.
⑧ Monitor output terminal (BNC type)
This terminal is used for video output. Connect this terminal to a monitor, etc.
By installing an HDMI option board (VA-HDB90; sold separately), the camera can be connected to a
high vision monitor.
②
Ⓐ
Ⓑ
①
⑤
2
④
⑥
⑦