Mounting The Camera Unit - Sanyo VCC-HD5600P Setup Manual

2. Mounting the camera unit

Fasten the camera unit safety wire (E) to the hook
(F) on the inner side of the power board unit.
Align the colored dot (blue) on the camera unit with
the arrow on the power board unit, and push the
camera unit until they click.
Align the colored dot (blue) on the inside of the
surface cover with the arrow on the power board
unit, and turn the surface cover in the direction of
the arrow to secure it in place.
■
How to attach the drop-prevention cable (accessory)
❶ Peel off the two-sided tape (J) at the end of the cable,
attach the cable end to the hook (K) on the inside of the
surface cover as shown in the figure, and then pull the
cable downward until the small protrusion (L) and the
hook (K) fit in the cable's first and second holes from the
top, respectively.
❷ Fasten the cable to the hook on the side of the power
board unit.
■
When routing cables through side face of power
board unit
■
To remove the camera unit
Push
❷
❶
J
K
Push
L
4
Installation
F
E
Surface cover
(Accessory)