Tekno Point COROLLA SRV-09H User Manual page 26

DRY OPERATION
1. Push the Mode button to select DRY.
2. Push the or button to set the desired temperature from 21 C to 2 8 C.
3. Push the On/off button. The operation lamp lights and the air conditioner starts to operate
in the DRY mode. Push the On/off button again to stop this unit operation.
NOTE:
Due to the difference of the set temperature of the unit and the actual indoor temperature,
the Air Conditioner when in DRY mode will automatically operate many times without
running the COOL and FAN mode.
TIMER OPERATION
Push Timer on/off button to set the on and off times of the unit. The effective operation time
set by the remote controller for the timer function is limited to a period of between 0.5 and
less than 24 hours.
1. To set the STARTING time.
1.1 Push the Timer on button, then the remote controller shows ON TIMER , the last set
time for the starting operation and the signal "Hr" will be shown on the Timer display area.
You are now ready to reset the time to START the operation.
1.2 Push the Timer on button again to set desired unit start time.
1.3 After setting the Timer on ,there will be a one-half second delay before the remote
controller transmits the signal to the air conditioner.
2. To set the STOPPING time.
2.1 Push the Timer off button and the remote controller will show OFF TIMER, the last set
time for the stopping operation and the signal "Hr" will be shown on the Timer display area.
You are now ready to reset the time of the STOP operation.
2.2 Push the Timer off button again to set the time you want to stop the operation.
2.3 After setting the Timer off ,there will be a one-half second delay before the remote
controller transmits the signal to the air conditioner.
3. Set the starting & stopping time
3.1 Push the Timer on button, the remote controller will show ON TIMER, the last set time
for START operation and the signal "Hr" will be shown on the Timer display area. You
are now ready to readjust the Timer on to start the operation.
3.2 Push the Timer on button again to set the time you want to start the operation.
3.3 Push the Timer off button, the remote controller will show OFF TIMER, the last set
time for STOP operation and the signal "Hr" will be shown on the Timer display area. You
are now ready to reset the time to STOP operation.
3.4 Push the Timer off button again to set the time you want to stop the operation.
3.5 After setting the TIMER, there will be a one-half second delay before the remote
controller transmits the signal to the Air Conditioner.
NOTE
If the same time is set for both START and STOPPING settings, the stopping time will
automatically increase 0.5hr(the set time displays less than 10Hr) or one hour (the set time
displays 10Hr or more). To change the Timer on/off time, just press the corresponding
TIMER button and reset the time.
The setting time is relative time. That is the time set is based on the delay of the current
time.
-28-