Adjusting Air Flow Direction - Tekno Point COROLLA SRV-09H User Manual

Wall mounted inverter-multiinverter type of air conditioner

Hide thumbs

Table Of Contents

Table of Contents

Available languages

TEMPORARY OPERATION

This function is used to operate the unit temporarily in case you misplace the remote controller or its

batteries are exhausted.

1. Open the pane land, lift the panel up to an angle where it remains fixed. Do not lift the panel

any further when it stops with a clicking sound.

2. Turn the switch to AUTO position and the air conditioner will run under AUTO mode.

3. Close the panel firmly to its original position.

CAUTION:

Once you push the temporary button, the air conditioner will run in such order: AUTO, COOL,

OFF, and back to AUTO.

Push the temperary button until the OPERATION lamp is lit, the unit is on the mandatory

COOL mode, this is used to test only, please don't choose it

When the OPERATION lamp goes off, the air conditioner is OFF.

Push the button on the remote controller will restore the remote operation.

Lever

The starting angle of the horizontal louver should not be too small, or the narrow air

outlet will affect cooling or heating.

Do not move the horizontal louver manually, or it may malfunction during operation. Lf

the malfunction happens, please stop operating, unplug for several minutes then plug

again and restart.

Do not operate the air conditioner for long with the airflow direction set downward

during the cooling or drying operation. Otherwise, condensation may occur on the

surface of the vertical louver and cause dew dripping.

When the air conditioner restarts the vertical louver might not move for 10 seconds or

so.

At the first time to operate, there may be some noise when horizontal louver is

turning, it is under control.