Dentsply Sirona Radica Provisional Directions For Use Manual page 9

Adding on to the
resin
Applying the sealer
9. For crowns, proceed to FINISHING THE PROVISIONAL, STEP 1.
10. After curing, allow the model/restoration to return to room
temperature before removing the cured restorations. This may be
accelerated by placing the model in cold/ice water.
11. Use a brush to apply a thin layer of the sealer to the bottom of the
pontic.
12. Place the bridge, upside down, on the Enterra or Eclipse Processing
Unit turntable or on the center of the Triad 2000 turntable and cure
according to the PONTIC CURE step on Table 1.
Removing the bridge
from the model
Clean up the excess
8
Excess resin removed
Curing the resin
Applying the sealer