Start-Up Procedure - Fayat Group BOMAG BP 10/35 Service Manual

1.2.6 Start-up procedure

1.2.6.1 Prior to starting up
1.2.6.2 Spark protection
1.2.6.3 Starting the engine
BP 10/35 / BP 12/40 / BP 12/50 / BVP 10/36 / BVP 12/50 / BVP 18/45
General – Concerning your safety
Danger to the life of persons if they step or stand under a sus-
pended load.
When lifting the machine avoid uncontrolled movements of the
load. If necessary hold the load with guide ropes.
Use only machines which are serviced at regular intervals.
Become acquainted with the equipment, the indicators and control
elements, the working principle of the machine and the working
area.
Use your personal protective equipment (hard hat, safety boots, if
necessary also goggles and ear protection).
Do not take any loose objects with you or fasten them to the
machine.
Before start up, check whether:
n persons or obstructions are beside or in front of the machine,
n the machine is free of oily and combustible materials,
n all safety elements are in place,
n all grips are free of grease, oils, fuel, dirt, snow and ice.
Before start up, carry out all required visual inspections and func-
tion tests.
If the following tests reveal damages or other faults, the machine
must not be operated, until these deficiencies have been corrected.
Do not operate the machine with defective indicators and control
elements.
The spark protection is optional.
In some areas of use operation of an engine without spark protec-
tion is not permitted.
Check the locally valid legislation and regulations.
Do not use any starting aids like start pilot or ether.
The machine must not be operated with damaged, missing or non-
functional safety installations.
Before starting and moving the machine make sure that there are
no persons inside the danger zone.
Operate the machine only with the steering bow mounted and low-
ered.
17