Table of Contents
Advertisement
Final Fitting
Fitting the Handles and Handrail (Classic)
Remove the 4 mm Allen screws from the doors (Fig. 9.13). Fit
the door handles and secure using the 4 mm screws.
The handles should be above the fixings.
n
Remove the 4 mm Allen screws from the top corners of the
fascia (Fig. 9.14). Fit the front handrail in position and secure
using the 4 mm screws.
Fitting the 1-piece Plinth (Professional+)
Loosen the three screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw. Twist
and fit each end keyhole over their respective screws. Tighten
the fixing screws (Fig. 9.15).
Fitting the 2-piece Plinth (Classic)
Fit the inner plinth to the bottom front of the cooker using
the 4 screws provided (Fig. 9.16).
Fit the outer plinth (2 screws, 1 each end) to the inner plinth.
The height of the outer plinth can be adjusted by sliding it up
or down via the slotted hole (Fig. 9.17).
Fitting the Splashback (Classic)
Position the splashback on the rear of the hotplate and secure
with the screws supplied.
Customer Care
Installer: Please complete your details in this guide, inform
the user how to operate the cooker and hand over the
instructions.
Thank you.
INSTALLATION
Check the appliance is electrically safe when you have finished.
ArtNo.215-0026 - Handle gaskets fixed
Art No 215-0028 - Handrail fascia fixings
ArtNo.350-0010 - Fitting the plinth 1 (Kitchener)
ArtNo.350-0011 - Fitting the plinth 2 (Kitchener)
Outer plinth xing screw
Inner plinth
33
Fig. 9.13
Fig. 9.14
Fig. 9.15
Fig. 9.16
Fig. 9.17
Outer plinth
Advertisement
Table of Contents
