Replas PREMIER SETTING 1.8m Free Standing Assembly Instructions

IMPORTANT: Please read carefully before assembling.
PREMIER
SETTING
1.8m
Free Standing
1. Place Table & Bench tops face down on a flat surface.
2. Place supports inside metal frame.
NOTE: Ensure that the Table Supports have the counter sink holes facing outwards on the
support upright
3. Using the 75mm bugle screws supplied, fit crossarm between the two table supports.
4. Using a 3.5mm drill bit, drill into the support through the pilot holes in the metal frame.
5. Using the 40mm Hex Screws supplied, screw support onto frame, taking care not to over tighten as
this could strip the thread in the support.
6. Once all screws have been tightened, turn setting over and place into position.
TABLE:
1 X Table Top ‐ pre‐assembled
2 X Table Supports
1 X Table Crossarm
4 X 14g x 75mm Bugle screws
16 X 12g x 40mm Hex Screws
ASSEMBLY INSTRUCTIONS
COMPONENTS LIST
BENCHES:
2 X Bench Tops ‐ pre‐assembled
4 X Bench Supports
24 X 12g x 40mm Hex Screws
If you require further installation
assistance, please contact your supplier.