Replas Premier Slimline Assembly Instructions

PREMIER
SLIMLINE SETTING
3 Support 1.8m
In Ground
TABLE:
1. Place table top face down on a flat surface.
2. Place Table supports into position.
3. Secure table supports to the 40x200mm planks using the 100mm hex screws, taking care not to over tighten as this could
strip the thread.
NOTE: Do not tighten screws until all are in position.
BENCHES:
1. Place bench slats face down on a flat surface.
2. Attach bench supports to the 40x90mm slats using the 65mm hex screws, taking care not to over tighten as this could
strip the thread.
NOTE: Do not tighten screws until all are in position.
Installation
Once the setting has been is assembled, drill or dig holes as per installation diagram.
Place the supports of the assembled setting into the holes. Position the setting and ensure that it is well braced to prevent
movement and sagging. At this stage it is important to use a spirit level to check that the top is horizontal and the supports are
vertical.
Once satisfied that the setting is positioned correctly, fill the holes with concrete, making sure it is packed firmly around the
supports.
Once the concrete has set, remove the bracing.
SUGGESTION:
When installing In‐Ground furniture it is a good idea to nail some timber bracing across the back of all supports. This will ensure
all supports are kept parallel and in alignment, as well as preventing any sagging of the seat during installation. Do not remove
bracing until after concrete has set.
TABLE:
1 X Table Top ‐ pre‐assembled
3 X Table Supports
24 X 14g x 100mm Hex Head screws
If you require further installation assistance, please contact your supplier.
ASSEMBLY INSTRUCTIONS
IMPORTANT: Please read carefully before assembling.
COMPONENTS LIST
BENCHES:
2 X Bench Tops ‐ pre‐assembled
6 X Bench Supports
30 X 14g x 65mm Hex Head Screws