Replas PREMIER SLIMLINE SETTING Assembly Instructions

IMPORTANT: Please read carefully before assembling.

PREMIER

SLIMLINE SETTING

1.8m

Free Standing

Place Table & Bench tops face down on a flat surface.

Place supports inside metal frame.

NOTE: Ensure that the Table Supports have the counter sink holes facing outwards on

the support upright

Using the 75mm bugle screws supplied, fit crossarm between the two table supports.

Using a 3.5mm drill bit, drill into the support through the pilot holes in the metal frame.

Using the 40mm Hex Screws supplied, screw support onto frame, taking care not to over tighten as

this could strip the thread in the support.

Once all screws have been tightened, turn setting over and place into position

TABLE:

1 X Table Top ‐ pre‐assembled

2 X Table Supports

1 X Table Crossarm

4 X 14g x 75mm Bugle screws

16 X 12g x 40mm Hex Screws

ASSEMBLY INSTRUCTIONS

COMPONENTS LIST

If you require further installation

assistance, please contact your supplier.

BENCHES:

2 X Bench Tops ‐ pre‐assembled

4 X Bench Supports

24 X 12g x 40mm Hex Screws

Table of Contents

Do you have a question about the PREMIER SLIMLINE SETTING and is the answer not in the manual?

Page 1 ASSEMBLY INSTRUCTIONS IMPORTANT: Please read carefully before assembling. PREMIER SLIMLINE SETTING 1.8m Free Standing 1. Place Table & Bench tops face down on a flat surface. 2. Place supports inside metal frame. NOTE: Ensure that the Table Supports have the counter sink holes facing outwards on the support upright 3. Using the 75mm bugle screws supplied, fit crossarm between the two table supports. 4. Using a 3.5mm drill bit, drill into the support through the pilot holes in the metal frame. 5. Using the 40mm Hex Screws supplied, screw support onto frame, taking care not to over tighten as this could strip the thread in the support. 6. Once all screws have been tightened, turn setting over and place into position COMPONENTS LIST TABLE: BENCHES: 1 X Table Top ‐ pre‐assembled 2 X Bench Tops ‐ pre‐assembled 2 X Table Supports 4 X Bench Supports 1 X Table Crossarm 24 X 12g x 40mm Hex Screws ...
Page 2 SIDE VIEW - Table only 8 x (40x90x1800) 1800 25 x 40 x 3mm Frame 40 x 90 x 1260 Cross Arm Concrete Slab 1270 SIDE VIEW - Bench only 3 x (40x90x1800) 1800 25 x 40 x 3mm Frame Concrete Slab SIDE VIEW Concrete Slab...