Installation Introduction - AGA 7 Series User's Manual & Installation Instructions

3.

Installation Introduction

Please refer to the eR7 or R7 guide for product
dimensions following the Module instructions.
Health and Safety
Consumer Protection
As responsible manufacturers we take care to make sure
that our products are designed and constructed to meet the
required safety standards when properly installed and used.
IMPORTANT: Please read the accompanying
n
warranty.
Any alteration that is not approved by AGA could invalidate
the approval of the appliance, operation of the warranty and
could also affect your statutory rights.
WARNING: This appliance shall be installed in
n
accordance with the regulations in force and only
used in a well ventilated space. Read the instructions
before installing or using this appliance.
CAUTION: This installation must conform with
n
local codes or, in the absence of local codes to the
national fuel gas code ANSI.Z223. I and national
electrical code ANSI/NFPA70 (in Canada CAN/
CGA-B149) and only used in a well ventilated space,
read the instructions before installing or using this
appliance.
• Prior to installation, ensure that the local distribution
conditions (nature of the gas and gas pressure) and the
adjustment of the appliance are compatible.
• The adjustment conditions for this appliance are stated
on the data plate.
• The data plate is situated in the centre vent slot near the
base of the front plate.
• This appliance is not connected to a combustion
products evacuation device. It shall be installed and
connected in accordance with current installation
regulations. Particular attention shall be given to the
relevant requirements regarding ventilation.
• It should be in accordance also with any relevant
requirements of the Gas Region and Local Authority.
• The appliance and its individual gas shut off valve must
be disconnected from the gas supply piping system
during any pressure testing of that system test pressure
in excess of 1/2 psi (3.5 kPa).
• The appliance must be isolated from the gas supply
piping system by closing its individual manual shut
off valve during any pressure testing of the gas supply
system at test pressures equal to or less than 1/2 psi (3.5
kPa).
• In your own interest, and that of safety to comply with
the law, all gas appliances must be installed by an AGA
approved installer. Failure to install appliances correctly
could lead to prosecution.
• On completion test the gas installation for soundness
and purge. Leak testing of the appliance shall be
conducted according to the manufacturers instructions.
• NOTE: Use soapy water solution on new gas
connections to ensure there are no gas leaks.
Delivery Requirements
These installation instructions should be left with the range
for the user to retain for future reference.
The AGA 7 Series Module arrives on 1 pallet and attaches to
an existing AGA 7 Series range, creating a seamless 5-oven or
7-oven configuration.
See the installation instructions for a detailed description.
If this skate/template can be manipulated through the
property grounds and doors into position, then the AGA
can be installed as intended with no re-work.
WARNING: THIS APPLIANCE MUST BE EARTHED.
n
• The appliance is designed for the voltage stated on the
data plate.
• The appliance is supplied with and installed adjacent to
the left-hand side of any one of the AGA range.
• Installation of the Module must, therefore, be in
conjunction with the build instructions of the 'parent'
AGA.
• Reference must be made to the above Installation
instructions for the 'parent' AGA especially regarding
pre-site inspection, not only for both cookers but to
consider any pipework that may pass at the rear of the
Module. i.e. boiler piping or flue duct from a Fan Flue
AGA.
• The appliance has been designed to accommodate
pipework passing at the rear.
• NOTE! THE MAIN AGA COOKER IS DELIVERED EX-
WORKS, UNASSEMBLED.
• Assembly is undertaken on site by an authorized
AGA distributor.
4