Varian Turbo-V 3KT Instruction Manual page 93

•
Press the PUMP CURRENT push-button to enter
the data.
The run up time is factory-set to:
00h 08m 00s.
•
Press the PUMP CURRENT push-button to enter
the data.
When the last digit is entered, the display shows:
D E L A Y E V E N
T H R E S H O L D :
where: XXX = YES or NO.
•
Press the CYCLE NUMBER push-button and
select YES if relay R2 must operate only after the
run-up time or select NO when the R2 operation is
needed right from start of the turbopump and after
the rotational speed of the turbopump exceeds for
the first time the speed threshold value (see the
preceding cycle diagram).
This function is factory-set to YES.
D E L A Y E V E N
T H R E S H O L D :
Press the PUMP CURRENT push-button and the
display shows:
V E N T V A L V E
X X X X X X X
where: XXX = CONTROLLED VENT or SERIAL
COMMAND
Turbo-V 3K-T
A F T E R
X X X
A F T E R
Y E S
Turbo-V 3K-T
M O D E
•
Press the PUMP CURRENT push-button. If VENT
VALVE MODE = AUTO MODE, the display shows:
V E N T V A L V E
Delay time of the vent valve from 0 to 999999
•
Press the PUMP CURRENT push-button. If VENT
VALVE MODE = AUTO MODE, the display shows:
V E N T
X X X X X
Opening time of the vent valve from 0 to 999999
•
Press PUMP CURRENT push-button and the display
shows:
S T O P
R E A D
where: XXX = YES or NO.
87
TECHNICAL INFORMATION
D E L A Y
X X X X X S
O P E N T I M E
S 0 = I N F
S P E E D
I N G : X X X
87-900-988-01 (B)