Varian Turbo-V 3KT Instruction Manual page 89

•
Enter the selection by pressing the PUMP CURRENT
push-button, and the display shows:
F R O N T / R E M O T E
S E L E C T I O N : X X X X X X
where: XXXXXX = means the word FRONT. REMOTE, or
SER depending on the last selection.
The controller is factory-set for FRONT panel operation.
SER will only be displayed if the optional serial card is
installed.
•
Choose the desired selection by pressing the CYCLE
push-button.
F R O N T / R E M O T E
S E L E C T I O N :
•
Press the PUMP CURRENT push-button to enter the
value and ,if the serial option is installed, the display
shows:
R S X X X
B A U D R A T E
Turbo-V 3K-T
where: BAUD RATE XXXX = means 600, 1200, 2400,
4800, 9600 baud rate for the host computer or printer
communication. The controller is factory-set for 9600 baud
rate operation.
The value which corresponds to the board installed will be
assigned to RSXXX.
/ S E R
Turbo-V 3K-T
/ S E R
F R O N T
X X X X
•
Press PUMP CURRENT push-button and the display
shows
S E R I A L
This message will only be displayed if the RS 485 module
is installed.
Where:
XX = 00 ÷ 31 is the unit address
•
If the RS 232 is installed, enter the value by pressing
the PUMP CURRENT push-button and, if the serial
option is installed, the display shows:
R S X X X
S E L E C T
This message will only be displayed if the RS232 interface
is present.
where: SELECTION: XXXXX = means HOST or PRINT.
The controller is factory-set to HOST
83
TECHNICAL INFORMATION
A D D R E S S
X X
Turbo-V 3K-T
H O S T / P R I
I O N : X X X X X
Turbo-V 3K-T
87-900-988-01 (B)
N T