Isuzu N 2008 Series Workshop Manual page 320

Engine control system
Hide thumbs Also See for N 2008 Series:
Table of Contents

Advertisement

Step
1.
Inspect the following conditions:
• Misrouted
differential pressure hoses or pipes
Important:
directionality in the exhaust differential
pressure
System in Section 1G Engine Exhaust.
• Plugged, crushed or kinked exhaust
differential pressure hoses or pipes
• Dislocated or inclined exhaust differential
pressure
System in Section 1G Engine Exhaust.
• Physical
differential pressure sensor
• Any contamination or objects that block
the exhaust differential pressure sensor
port
• Skewed or slow exhaust differential
pressure sensor
• An exhaust system gasket that is missing
or damaged
4
• Exhaust gas leakage from the exhaust
pipe, gasket, DPD assembly, exhaust
temperature
differential pressure hoses or pipes
• Modified exhaust system
• Exhaust throttle valve or exhaust brake
valve for stuck condition. Refer to
exhaust system section for diagnosis.
• Skewed or slow exhaust temperature
sensors
• Restricted air cleaner element, restricted
or collapsed air tubing between the air
cleaner and the intake manifold
• Modified air induction
• Any air induction leak
• Any contamination or objects that block
the mass air flow (MAF) sensor inlet
• Skewed or slow MAF sensor
2.
Repair or replace as necessary.
Did you find and correct the condition?
Start the engine and let idle for 30 seconds.
5
Does the DPD amber lamp or "PUSH DPD
SWITCH" indicator blink?
Perform the DPD manual regeneration by pressing
the DPD regeneration switch.
6
Does the regeneration start?
Observe the DPD Accumulation Status and DPD
Distance Status with a scan tool, and plot both
7
readings on the DPD status table.
Is the intersected range located in A or B?
Action
or
disconnected
exhaust
There
is
installation
hoses.
Refer
to
Exhaust
sensor.
Refer
to
Exhaust
damage
of
the
exhaust
sensor(s)
or
exhaust
Engine Control System (4JJ1)
Value(s)
Yes
Go to Step 14
Go to Step 6
Go to Step 10
Go to Step 8
1A-317
No
Go to Step 5
Go to Step 7
ECM is not allowing
the DPD
regeneration
control. Refer to
Test Description and
DTC List
Go to Step 9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

4jj1

Table of Contents