1A-270
Engine Control System (4JJ1)
Step
1.
Reconnect
harness connector(s) or components.
2.
Turn ON the ignition for 30 seconds. DO NOT
start the engine. (This is to relearn exhaust
differential pressure sensor.)
3.
Clear the DTC and reset the DPD Status with
6
a scan tool.
4.
Turn OFF the ignition for 30 seconds.
5.
Perform the DPD Normal Regeneration with a
scan tool.
Did you complete the action?
1.
Observe
parameter with a scan tool. Make sure the
temperature is less than 140 °C (284 °F). If
more than 140 °C (284 °F), let increase 1500
RPM without load. (Turn the idle up control
knob clockwise.)
2.
Accelerate the engine to W.O.T. (accelerator
7
pedal full travel) and read the Exhaust
Differential Pressure parameter when the
Exhaust Temperature 1 parameter is reached
to 150 °C (302 °F)
Is the Exhaust Differential Pressure parameter less
than the specified value?
Observe the DTC Information with a scan tool.
8
Are there any DTCs that you have not diagnosed?
Action
all
previously
disconnected
the
Exhaust
Temperature
Value(s)
—
1
4.4 kPa
—
Yes
Go to Step 7
Ash cleaning must
be performed. Refer
to appropriate
procedure in
Section 1G Engine
Go to Step 8
Go to DTC List
No
—
Exhaust
System OK