Isuzu N 2008 Series Workshop Manual page 283

1A-280 Engine Control System (4JJ1)
Step
1. Turn ON the ignition, with the engine OFF.
2. Clear the DTC and the DPD Status with a
scan tool.
3. Turn OFF the ignition for 30 seconds.
6
4. Perform the DPD Normal Regeneration with a
scan tool.
Did you complete the action?
1. Observe
parameter with a scan tool. Make sure the
temperature is less than 140 °C (284 °F). If
more than 140 °C (284 °F), let increase 1500
RPM without load. (Turn the idle up control
knob clockwise.)
2. Accelerate the engine to W.O.T. (accelerator
7
pedal full travel) and read the Exhaust
Differential Pressure parameter when the
Exhaust Temperature 1 parameter is reached
to 150 °C (302 °F).
Is the Exhaust Differential Pressure parameter less
than the specified value?
Observe the DTC Information with a scan tool.
8
Are there any DTCs that you have not diagnosed?
Action
the Exhaust Temperature
Value(s)
—
1
4.4 kPa
—
Yes
Go to Step 7
Ash cleaning must
be performed. Refer
to appropriate
procedure in
Section 1G Engine
Go to Step 8
Go to DTC List
No
—
Exhaust
System OK