Dtc P0697 (Flash Code 57) - Isuzu N 2008 Series Workshop Manual

1A-214 Engine Control System (4JJ1)

DTC P0697 (Flash Code 57)

Circuit Description
The ECM provides 5 volts reference voltage through
the reference circuit 3 to the following sensors:
• Exhaust differential pressure sensor
• Exhaust temperature sensor 1
• Exhaust temperature sensor 2
The ECM also provides 5 volts reference voltage
through the reference circuit 4 to the following sensors:
• Crankshaft position (CKP) sensor
• Boost pressure sensor
• Intake throttle position sensor
• Variable nozzle turbocharger (VNT) vacuum
pressure sensor
• Engine coolant temperature (ECT) sensor
• Fuel temperature (FT) sensor
The 5 volts reference circuits 3 and 4 are independent
of each other outside of the ECM, but are bussed
together inside the ECM. Therefore, a short circuit
condition on one sensor 5 volts reference circuit may
affect the entire 5 volts reference circuit 3 and 4. The
ECM monitors the voltage on the 5 volts reference
circuit 3 and 4. If the ECM detects the voltage is
excessively low or high, this DTC will set.
Condition for Running the DTC
• DTC P060B is not set.
• The battery voltage is between 18 to 32 volts.
Circuit/ System Testing DTC P0697
Step
Did you perform the Diagnostic System Check -
1 Engine Controls?
1. Install a scan tool.
2. Turn OFF the ignition for 30 seconds.
3. Start the engine.
2
4. Monitor the DTC Information with a scan tool.
Does the DTC fail this ignition?
1. Turn OFF the ignition.
2. Disconnect
harness connector.
3. Connect a DMM between the 5 volts reference
3
circuit (pin 3 of E24) and a known good
ground.
4. Turn ON the ignition, with the engine OFF.
Is the DMM voltage less than the specified value?
Is the DMM voltage more than the specified value
4
at Step 3?
Action
the boost pressure
• The ignition switch is ON.
Condition for Setting the DTC
Either of following condition is met:
• The ECM detects that the 5 volts reference circuit
3 or 4 voltage is less than 4.5 volts.
• The ECM detects that the 5 volts reference circuit
3 or 4 voltage is more than 5.5 volts.
Action Taken When the DTC Sets
• The ECM illuminates the MIL when the diagnostic
runs and fails. Refer to DTC Type Definitions for
Action Taken When the DTC Sets - Type A.
• The ECM limits fuel injection quantity.
• The ECM inhibits pre injection.
• The ECM inhibits EGR control.
Condition for Clearing the DTC
• Refer to DTC Type Definitions for Condition for
Clearing the MIL/ DTC - Type A.
Diagnostic Aids
• If an intermittent condition is suspected, refer to
Intermittent Conditions in this section.
Connector End View Reference: Engine Controls
Connector End Views or ECM Connector End Views
Value(s)
—
—
sensor
5.5 volts
4.5 volts
Yes
Go to Diagnostic
System Check -
Go to Step 2 Engine Controls
Go to Diagnostic
Go to Step 3
Go to Step 4 Go to Step 10
Go to Step 11 Go to Step 5
No
Aids