Isuzu N 2008 Series Workshop Manual page 110

Step
1. Test the signal circuit between the ECM (pin
84 of E12) and the ECT sensor (pin 1 of E25)
for the following conditions:
• A short to ground
5
• A short to the low reference circuit
2. Repair the circuit(s) as necessary.
Did you find and correct the condition?
Replace the ECT sensor. Refer to ECT Sensor in
Section 1C Engine Cooling.
6
Did you complete the replacement?
1. Turn OFF the ignition.
2. Disconnect the ECM harness connector.
3. Inspect connections at the harness connector
of the ECM (pins 84 and 109 of E12) for
7
corrosion.
4. Repair or
necessary.
Did you find and correct the condition?
Important:
programmed and learned.
8
Replace the ECM. Refer to ECM Replacement.
Did you complete the replacement?
1. Reconnect
harness connector(s).
2. Clear the DTCs with a scan tool.
3. Turn OFF the ignition for 30 seconds.
4. Start the engine.
9
5. Operate the vehicle within the Conditions for
Running the DTC. You may also operate the
vehicle
observed from the Freeze Frame/ Failure
Records.
Did the DTC fail this ignition?
Observe the DTC Information with a scan tool.
10
Are there any DTCs that you have not diagnosed?
Circuit/ System Testing DTC P0118
Step
Did you perform the Diagnostic System Check -
1 Engine Controls?
1. Install a scan tool.
2. Turn OFF the ignition for 30 seconds.
3. Start the engine.
2
4. Monitor the DTC Information with a scan tool.
Is DTC P0697 also set?
Action
clean the connection(s)
Replacement ECM
all previously disconnected
within the conditions
Action
Engine Control System (4JJ1)
Value(s)
—
—
—
as
must be
—
—
that you
—
Value(s)
—
—
Yes
Go to Step 9
Go to Step 9
Go to Step 9
Go to Step 9
Go to Step 3
Go to DTC List
Yes
Go to Diagnostic
System Check -
Go to Step 2 Engine Controls
Go to DTC P0697
1A-107
No
Go to Step 7
—
Go to Step 8
—
Go to Step 10
System OK
No
Go to Step 3