1A-136
Engine Control System (4JJ1)
Step
Replace the BARO sensor. Refer to BARO Sensor
Replacement.
9
Did you complete the replacement?
1.
Reconnect
harness connector(s).
2.
Clear the DTCs with a scan tool.
3.
Turn OFF the ignition for 30 seconds.
4.
Start the engine.
10
5.
Operate the vehicle within the Conditions for
Running the DTC. You may also operate the
vehicle
observed from the Freeze Frame/ Failure
Records.
Did the DTC fail this ignition?
Observe the DTC Information with a scan tool.
11
Are there any DTCs that you have not diagnosed?
Action
all
previously
disconnected
within
the
conditions
Value(s)
—
—
that
you
—
Yes
Go to Step 10
Go to Step 2
Go to Step 11
Go to DTC List
No
—
System OK