Midi Clock - GigRig G3 User Manual

THE ADVANCED SWITCHING SYSTEM

MIDI CLOCK

G3's MIDI CLOCK enables you to send a MIDI clock message that can sync all
your clock input enabled, time-based effects. You can send the MIDI clock out
on all MIDI channels.
There are two states to the MIDI clock:
- PL/PS (Play and Pause)
In this mode:
When the MIDI clock enabled footswitch is engaged, the MIDI clock will begin to run. When
the footswitch is pressed for a second time, it will pause the MIDI clock. Pressing this
footswitch multiple times will toggle between the two states.
- PLAY
In this mode:
When a MIDI clock enabled footswitch is engaged, the MIDI clock will start running at the
specified tempo and will continue to run until you leave this state.
MIDI Sent on preset OFF (StompBox mode) CC- PC- CC~ PC~ PC+
We've added a MIDI mode that enables you to send a separate MIDI message when you turn a StompBox mode
preset OFF, and another mode that will send a MIDI message when you leave a preset.
~ To send a PC/CC MIDI message when you turn a StompBox mode preset off, select the ~ mode in the MIDI
mode options. This mode is specifically for StompBox mode presets. When the StompBox mode preset is
pressed, the preset is selected and any + MIDI messages are sent. When pressed again, the ~ MIDI
messages are sent.
– To send a MIDI message when you leave a preset, select the – mode in the midi options.
You can use any of these midi messages under a single footswitch.
MIDI Sequencer
The G3 MIDI Sequencer enables you to send a string of MIDI commands.
To programme the MIDI Sequencer.
1. Go to MIDI and select seq enable
2. Programme the MIDI messages you want to sequence in the list of MIDI messages using the PCs and CCs
modes. If you want a gap in the midi sequence, use the 'null' message by selecting seq rate
footswitches 1 & 2 to adjust rate as needed.
3. Adjust the sequencer rate.
THE GIGRIG G3 USER MANUAL
(4)
(4) then use
19