GigRig G3 User Manual page 10

THE ADVANCED SWITCHING SYSTEM
c. Select the loops you want to pair. The red LED indicates two loops are paired in stereo.
d. Select the stereo loop by pressing either of the paired loops.
What is High Def Isolation?
TheGigRig High-Def Isolation is the new standard on all our products that feature isolated phase reversable
outputs, including G3, Atom, HumDinger and ABY BABY.
Instead of using an audio transformer, we use a differential signal sent to a mixer allowing you to isolate the
signal and flip the phase without being subject to any of the inherent characteristics of an audio transformer.
It's as close to a true mirror image of the input as is possible and is the new standard for signal isolation.
CONNECTING AMPLIFIERS' EFFECTS LOOP
There are three important steps to connecting to your amplifier's effects loop.
The best way to explain this is to think of your amps' pre-amp as another pedal. Your pre-amp is connected to
your amps power section and this is where the amps FX LOOP sits, between the preamp and power amp.
a. First select a G3 loop to connect with your amps FX loop. In the diagram above, loops 1-4 are placed
before the preamp, loop 5 contains the preamp and loops 6-12 are placed inside the FX loop (note - any
loop can be selected).
b. Connect the SEND from the chosen G3 effects loop to the input of the amplifier. The connections
needed to achieve this are:
c. G3 Loop 5 SEND to AMP INPUT.
d. AMP FX Loop SEND to G3 Loop 5 RETURN.
e. G3 Atom Output 1 to AMP FX Loop RETURN.
f. As the amp's pre-amp is contained within Loop 5, this needs to be engaged on all presets.
THE GIGRIG G3 USER MANUAL
10