Positioning The Cutter Head On The Arm; Positioning The Cutter Head For Miter Cuts; Pivoting The Cutter Head For Ripping - General International 50-755 M1 Setup & Operation Manual

MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-
ING ANY MAINTENANCE OR ADJUSTMENTS.
POSITIONING OF THE CUTTER HEAD ON THE ARM
1. Loosen the lock lever A.

POSITIONING THE CUTTER HEAD FOR MITER CUTS

B
1. Loosen lock lever B, then unlock the arm by lifting
lock lever C.

PIVOTING THE CUTTER HEAD FOR RIPPING

1. Unplug the machine from the power source. Dis-
connect the cutter head from the return spring
and then unlock the cutter head by turning lever E to
the left.
18
A
C
E
2. Place the cutter head on the radial arm as per the
desired position and retighten the lever A.
2. Using the graduated scale D, position the arm to
the desired angle, then retighten lock lever B.
Note: To position the saw at 45º, lock the lever C into the
groove in the column.
F
2. While lowering lever F pivot the cutter head to the
right or to the left to the desired position. Lock the
cutter in position by tightening the lever E.
Note: Once it is released, the spring loaded lever F pin will
click into the ripping position.
D