ICP DAS USA M-7019Z Quick Start Manual page 4

10-channel universal voltage input & current input, thermocouple input module

5. Configuration

To install the module, follow the steps below:

1. Connect the thermistor analog input.

2. Connect the module to the RS-485 network using the DATA+ and DATA- terminals. If

the host is only equipped with an RS-232 interface, then an RS-232 to RS-485

converter will be required.

3. Connect the module to the power supply using the +Vs and GND terminals. Note that

the voltage supplied should be in the range of +10 to +30V DC.

M-7019Z 10-channel Thermocouple, Current and Voltage AI Module- QuickStart (Sep/2017)

ICP DAS USA, Inc. |

www.icpdas-usa.com

| 1-310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717