Juniper Day One+ ACX7100-32C Manual page 9

4. Start the CLI.
[vrf:none] root@re0:~# cli
5. Enter configuration mode.
root@re0> configure
6. Stop the chassis auto-upgrade process.
[edit]
root@re0# delete chassis auto-image-upgrade
7. Stop zero-touch provisioning (ZTP).
[edit]
root@re0# delete system commit factory-settings
NOTE: ZTP is enabled on the ACX7100-32C in the factory-default configuration. You must stop ZTP before
you configure any settings. Until you assign a root password and make an initial commit, you might see
ZTP-related messages on the console. You can safely ignore these messages while you configure the root
password.
8. Add a password for the root administration user account.
[edit]
root@re0# set system root-authentication plain-text-password
New password: password
Retype new password: password
9. Commit the configuration, and wait for the ZTP process to stop.
[edit]
root@re0# commit
A message appears on the console, confirming that the ZTP process has stopped.
root@re0# [ 968.635769] ztp.py[20083]: 2021-06-09 16:47:52 INFO: ZTP: aborted in state
DISCOVERING_INTERFACES
[ 968.636490] ztp.py[20083]: 2021-06-09 16:47:52 INFO: ZTP: checkZTPAbort: Upgrade detected
pending abort
[ 968.636697] ztp.py[20083]: 2021-06-09 16:47:52 INFO: ZTP: aborted by user config commit
[ 968.782780] ztp.py[11767]: Notice: PID found for app ztp in /var/run/pid/ztp.pid is
20083.Executing command: (/usr/sbin/cleanzk -c /var/run/zkid/20083.id;rm /var/run/zkid/20083.id
9