Table of Contents
Advertisement
Installing the controller module
After you have replaced the component in the controller module, you must re-install the controller module
into the chassis, and then boot it to Maintenance mode.
A A b b o o u u t t t t h h i i s s t t a a s s k k
You can use the following steps to install the replacement controller module in the chassis.
A video for this task is available at:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C8THdP1nmPF25RWwGRta3v
P P r r o o c c e e d d u u r r e e
Step 1.
Close the controller module cover and tighten the thumbscrew.
1
2
Step 2.
Insert the controller module into the chassis:
a.
Ensure the latching mechanism arms are locked in the fully extended position.
b.
Using both hands, align and gently slide the controller module into the latching mechanism
arms until it stops.
c.
Cross your arms and place your index fingers through the finger holes from the inside of the
latching mechanism.
d.
Press your thumbs down on the orange tabs on top of the latching mechanism and gently
push the controller module over the stop.
ThinkSystem DM5100F Hardware Installation and Maintenance Guide
80
Controller module cover
Thumbscrew
Advertisement
Table of Contents
