Table of Contents
Advertisement
Step
Cable the wrench ports to the management network switches with the RJ45 cables.
DO NOT plug in the power cords at this point.
Step 2.
To complete setting up your system, see "Completing system setup and configuration" on page 20
Cabling a switched cluster
All ports on the controllers are connected to switches; cluster interconnect, management, Fibre Channel, and
data or host network switches.
B B e e f f o o r r e e y y o o u u b b e e g g i i n n
You must have contacted your network administrator for information about connecting the system to the
switches.
A A b b o o u u t t t t h h i i s s t t a a s s k k
Be sure to check the illustration arrow for the proper cable connector pull-tab orientation.
Note: As you insert the connector, you should feel it click into place; if you do not feel it click, remove it, turn
it around and try again.
P P r r o o c c e e d d u u r r e e
Step 1.
Use the step-by step instructions to complete the cabling between the controllers and to the
switches:
Pull-tab
Perform on each controller
Chapter 3
.
System installation and setup
15
Advertisement
Table of Contents
