Table of Contents
Advertisement
Step
Perform on each controller module
1
Cable ports 2a through 2d to the FC host switches.
2
To perform other optional cabling, choose from:
• "Cabling to a 25GbE data or host network" on page 18
• "Cabling the controllers to a single drive shelf" on page 19
3
To complete setting up your system, see "Completing system setup and configuration" on page
20.
Cabling to a 25GbE data or host network
25GbE ports on the controllers are connected to 25GbE data or host network switches.
B B e e f f o o r r e e y y o o u u b b e e g g i i n n
You must have contacted your network administrator for information about connecting the system to the
switches.
A A b b o o u u t t t t h h i i s s t t a a s s k k
Be sure to check the illustration arrow for the proper cable connector pull-tab orientation.
Pull-tab
Note: As you insert the connector, you should feel it click into place; if you do not feel it click, remove it, turn
it around and try again.
ThinkSystem DM5100F Hardware Installation and Maintenance Guide
18
Advertisement
Table of Contents
