Table of Contents
Advertisement
Step
Cable the wrench ports to the management network switches with the RJ45 cables.
DO NOT plug in the power cords at this point.
Step 2.
To complete setting up your system, see "Completing system setup and configuration" on page 20.
Cabling configuration-dependant options
You have configuration-dependant optional cabling to the Fibre Channel or iSCSI host networks or direct-
attached storage. This cabling is not exclusive; you can have cabling to a host network and storage.
Cabling to a Fibre Channel host network
Fibre Channel ports on the controllers are connected to Fibre Channel host network switches.
B B e e f f o o r r e e y y o o u u b b e e g g i i n n
You must have contacted your network administrator for information about connecting the system to the
switches.
A A b b o o u u t t t t h h i i s s t t a a s s k k
Be sure to check the illustration arrow for the proper cable connector pull-tab orientation.
Pull-tab
Note: As you insert the connector, you should feel it click into place; if you do not feel it click, remove it, turn
it around and try again.
Perform on each controller
Chapter 3
.
System installation and setup
17
Advertisement
Table of Contents
