Page 1
Ярославль (343)384-55-89 (4742)52-20-81 (8412)22-31-16 (8652)20-65-13 (4852)69-52-93 Иваново (4932)77-34-06 Киргизия Россия Казахстан (996)312-96-26-47 (495)268-04-70 (772)734-952-31 https://lamborghini.nt-rt.ru/ || hgc@nt-rt.ru BAJAS EMISIONES JEREZ ECO Basso NOx - Emisii reduse de NOx Niska emisja NOx - Low NOx INSTRUCTIONS FOR USE, INSTALLATION AND MAINTENANCE...
Page 2
JEREZ ECO GENERAL WARNINGS • Read the warnings contained in this contact registered technicians. The unit manual carefully. must only be repaired, and its compo- nents replaced, by registered techni- • Once the unit is installed, describe its cians using original replacement parts.
JEREZ ECO product. Such representations may in- • APPLIANCE INTENDED FOR DOME- clude slight, insignificant differences STIC USE; NOT VALID FOR INDU- with respect to the product supplied. STRIAL USE. This symbol means “Caution,” and is displayed next to safety war- nings.
Turn the knob to the required water heating level. 1.1 Introduction The unit will begin operating every time hot water is The new JEREZ ECO is a high-performance, low-emis- drawn. sion heater for domestic hot water production, powered by natural gas or LPG and equipped with a compact, WATER-COOLED, battery-powered burner with electro- nic ignition, designed for indoor installation.
JEREZ ECO 1.4.2 Setting the temperature Activation of Damaged or Check that the Turn the water temperature selector clockwise to incre- the over- badly positio- heating sensor is ase the temperature, or counterclockwise to decrease it. temperature ned heating properly installed...
JEREZ ECO dispersed in the domestic environment. OTHERWI- 2.3 Assembling the heater SE THERE MAY BE RISK OF SUFFOCATION AND IN- Before assembling the heater, TOXICATION OR EXPLOSIONS AND FIRE.. Therefore make sure the water and gas the place of installation must be free of dust, flam- connections are properly secu- mable materials or objects or corrosive gases.
• Remove the plugs from the water and gas connections (see fig. 8). • On the rating label, check the destination country refe- rence and the type of gas for which the unit is supplied. JEREZ ECO 11 Appr. nr. CA.1M Ser.n. 1905G80032 B11BS mod.
JEREZ ECO If the water hardness is over 25ºFr (1ºF=10ppm damage to the unit due to excess pressure, leave the CaCO3), the water must be treated to avoid gas inlet valve closed. possible deposits on the unit. 4 Check that the supplied pressure and gas delivery 2.4.1 Water flow rate adjustment...
JEREZ ECO Remember to make an air inlet opening in the room where the water heater is installed (as re- quired by the current regula- tions). If the above instructions are not observed there may be risk of suffocation or poisoning due to gas or fumes escaping.
JEREZ ECO unit. • Make sure the grounding and connection to the electri- cal network are adequate. • Check that the gas pressure is correct. • Make sure there are no flammable liquids or materials near the heater. • To avoid damaging the connections, do not place the heater on the floor with the connections facing down.
JEREZ ECO 3.4 REPLACING THE BATTERIES To change the batteries, proceed as described in fig. 18. 3.5 mm fig. 16 - Electrode position • The gas and water systems are perfectly tight. • The gas delivery and operating pressure values are as indicated on the tables. A soft, damp cloth may be used to clean the casing and exterior parts of the heater, using soapy water if neces- sary.
Need help?
Do you have a question about the JEREZ ECO and is the answer not in the manual?
Questions and answers