Removal·installation (W/Lift Bracket) (Pn Model) - Toyota 8FGU 15 Repair Manual Supplement

3-6 3-6
REMOVAL·INSTALLATION (W/LIFT BRACKET) (Pn model)
4
Removal Procedure
1 Set the mast vertical.
2 Remove the fork. (Refer to page 11-31 of 8FGU/8FDU15~32 repair manual vol.1 (Pub. No. CU052))
3 Remove the connector bracket, disconnect the connector of the fork height switch.
4 Disconnect the overflow hose and high pressure hose. (Before hose disconnection, fully lower the inner mast
and operate the lift lever several times to release the residual pressure from the lift cylinder.)
5 Slightly hoist the mast.
6 Remove the mast support cap.
7 Remove the tilt cylinder front pin. [Point 1]
8 Remove the mast ASSY W/ lift bracket.
9 Remove the tilt bracket bushing from the mast. [Point 2]
8
4
2
T = N·m (kgf·cm) [ft·lbf]
T = 96.0 (979) [70.8]
7
3
T = 84.0 ~ 156.0
(857 ~ 1591)
[62.0 ~ 115.1]
6