Toyota 8FGU 15 Repair Manual Supplement page 67

4-22 4-22
Installation Procedure
The installation procedure is the reverse of the removal procedure.
Note:
• Apply molybdenum disulfide grease on the portions for inserting tilt cylinder front and rear pins before
installation.
• Pre-coated bolts are used for the tilt cylinder rear pin set bolt. When installing, either replace the set bolt
with a new part or apply locking agent (08833-76001-71 (08833-00070)) to the threaded portion before
tightening.
• After installation, add molybdenum disulfide grease through the grease nipple to the tilt cylinder front
pin.
• After installation, slowly tilt the mast forward and backward a few times to check normal functioning.
• Check the hydraulic oil level, and add if insufficient.
• After installation, perform SAS matching. (Refer to section 16 of 8FGU/8FDU15-32 repair manual vol.1
(Pub. No. CU052))
SST(2)
Vehicle inside
Bushing
Bushing
Flush Flush
surfaces surfaces
(2 ~ 2.5 mm (0.08 ~ 0.10 in))
Pn1 ton series Except Pn1 ton series
Point Operations
[Point 1]
SST
Removal:
[Point 2]
Removal•Installation:
SST(1)
Vehicle inside
Installation:
(2 ~ 2.5 mm
(0.08 ~ 0.10 in))
SST 09810-20172-71
SST 09950-76018-71................................. (1)
(09950-60010)
09950-76020-71................................. (2)
(09950-70010)
When installing, ensure that the end face of the tilt cylinder
rear bushing is flush with the end face of the boss on the inside
of the vehicle.