Removal·installation - Toyota 8FGU 15 Repair Manual Supplement

4-10 4-10
REMOVAL·INSTALLATION
7
Removal Procedure
1 Set the mast vertical and lower the fork fully.
2 Remove the lift cylinder rod end set bolt.
3 Hoist the inner mast by slinging with a wire and disconnect the end of each lift cylinder rod. [Point 1]
4 Hoist the inner mast further so that the lift cylinder ASSY can be removed toward the front of the vehicle.
5 Support the bottom of the inner mast with wooden blocks and fix the blocks by taping onto the outer mast.
6 Remove the hose cover. (V mast)
7 Disconnect the low pressure hose and high pressure hose.
8 Remove the lift cylinder bottom end set bolt.
9 Remove the lift cylinder support. [Point 2]
10 Remove the lift cylinder ASSY.
7
6
10
5
2
9
8