Toyota 8FGU 15 Repair Manual Supplement page 33

3-4 3-4
Installation Procedure
The installation procedure is the reverse of the removal procedure.
Note:
• Apply molybdenum disulfide grease to the inner surface of the mast support bushing, the mast support
section of the front axle, and the tilt cylinder front pin.
• After installation, apply molybdenum disulfide grease to the mast support section and add molybdenum
disulfide grease through the grease nipple of the tilt cylinder front pin.
• Adjust lift cylinder uneven movement using shims when any of the mast ASSY, outer mast, inner mast or
lift cylinder is replaced. (Refer to page 11-50 of 8FGU/8FDU15~32 repair manual vol.1 (Pub. No. CU052))
• Adjust the chain tension after installation. (Refer to page 11-31 of 8FGU/8FDU15-32 repair manual vol.1
(Pub. No. CU052))
• When the mast is replaced, perform SAS matching after installation. (Refer to section 16 of 8FGU/
8FDU15~32 repair manual vol.1 (Pub. No. CU052))
SST
Point Operations
[Point 1]
Removal•Installation:
[Point 2]
SST
Removal:
[Point 3]
Removal:
SST
SST 09630-23600-71
If the fitting is hard, use the SST for removal.
SST 09950-76014-71
(09950-40011)
SST 09810-20172-71