Body; Toe Board Removal·installation - Toyota 8FGU 15 Repair Manual Supplement

5-2 5-2

BODY

TOE BOARD REMOVAL·INSTALLATION
2
Removal Procedure
1 Remove the mat.
2 Remove the lower panel.
3 Remove the rear toe board.
4 Disconnect the accelerator connector and harness clamp. (Vehicles with accelerator sensor) [Point 1]
Alternatively, disconnect the accelerator cable.
5 Remove the front toe board.
Installation Procedure
The installation procedure is the reverse of the removal procedure.
5
Point Operations
[Point 1]
Removal: 4Y engine vehicle
When moving the toe board aside for servicing, disconnect the
accelerator cable harness clamps (x2) from the toe board with
the accelerator connector connected.
Clamp
3