Toyota 8FGU 15 Repair Manual Supplement page 38

NJljǧ
Shim
Point Operations
Shim
[Point 1]
Disassembly:
[Point 2]
Disassembly:
Reassembly:
[Point 3]
Inspection:
A
B
Shim adjustment is made at the lift cylinder rod end to prevent
uneven lifting by lift cylinders LH and RH.
Note the cylinder that was adjusted and the number of shims
used.
Take a note on the number of cylinder support shims in use.
Make cylinder support shim adjustment if the mast or either
cylinder is replaced.
With the cylinder rod end inserted to the inner mast, insert
shim(s) between the cylinder support and outer mast to
eliminate the clearance. The shim thickness should be slightly
greater than the clearance.
Measure the mast strip thickness.
Limit: A=2.7 mm (0.106 in)
B=1.3 mm (0.051 in)
3-9