Toyota 8FGU 15 Repair Manual Supplement page 92

[A] Section page
Indicates the page number for the section.
[B] System title
Indicates a system name.
[C] Part name and connector code
Indicates a part name and connector code to be
connected.For connector shapes, refer to chapter
6 CONNECTOR LIST.
C7 Part connector
The wire harness in which the connector is
located.
Example: "C" indicates a connector used in
the C wire harness.
For wire harness names, refer to Chapter 2
ELECTRICAL WIRING ROUTINGS and
RELAY LOCATIONS.
Serial number allocated to the connector
D11 (A), D42 (D)
Connector number
Used to indicate different connectors when
multiple connectors are connected to a part,
or multiple types of connectors are used
according to specifications.
[D] Fuse
Indicates a fuse name and capacity.
Terminal 1 is on the primary side and terminal 2 is
on the secondary side.
For fuse installation positions, refer to chapter 2
ELECTRICAL WIRING ROUTINGS and RELAY
LOCATIONS.
[E] Power supply information
Indicates the ignition key position when power is
supplied to a fuse.
[F] Specification information
Indicates that connectors or wire colors vary
depending on forklift models, engine types or
specifications.
INTRODUCTION
[G] Page-to-page connection code
Indicates a wire harness continues onto the
following page from the matching code.
[H] Harness to harness connector
Indicates a connector code that connects two wire
harnesses.
For the connector shape, refer to chapter 6
CONNECTOR LIST.
Harness to harness connector
Terminal number
8
A K 1
Wire harness to be connected
Example: "AK" means a connection of the
female connector*1 of the "A" wire and the
male connector*2 of the "K" wire.
*1: A female connector has a female
*2: A male connector has a male
Serial number of a connector
Male terminal side
terminal.
terminal.
E1-7