Table of Contents
Advertisement
5.3.1 Power Supply
The power cable with a rated capacity of 10A should be used. Suggest using NSR PS-10 Power Supply Unit (DC
24V output).
5.3.2 GNSS Data Input
The input data format should be NMEA0183/4800bps, as IEC61162-1 standard. Refer to the installation drawings.
5.3.3 Connect to Printer
As an optional device, NSR NPT-100 is recommended as the printer used for NVR-3000.
- Part No. : NPT-100
- Rating : DC6.5V, 15W
Description
PRINTER（+）
PRINTER（-）
Necessary settings are needed for NPT-100 before properly working with NVR-3000. Please refer to the manual
supplied by the printer maker. The settings include the following parameters:
- Serial port setting
The output of NPT-100 should be set as SERIAL.
- Baud rate setting
NPT-100's baud rate can be 75, 110, 150, 300, 600, 1200, 2400, 4800, 9600, 19200bps. As the default rate, both
NVR-3000 and NPT-100 have been set at 4800bps in factory.
5.3.4 Connect to (S)VDR
Please refer to the attached drawings for the connection and wiring.
5.3.5 Connect to BAM/INS
Please refer to the attached drawings for the connection and wiring.
P1 Pin No.
5
6
NVR-3000 P1 plug
Pin No.
7
9
P2 Pin No.
7
8
P1 Pin No.
1
2
3
4
NVR-3000 OPERATION MANUAL & INSTALLATION MANUAL
Description
GNSS Input (RXA)
GNSS Input (RXB)
NPT-100 plug（RS232，9 pins）
Pin No.
---------------
3
---------------
5
Description
VDR Audio （+）
VDR Audio （-）
Description
BAM/INS (TXA)
BAM/INS (TXB)
BAM/INS (RXB)
BAM/INS (RXA)
73
Description
RXD
GND
NVR-3000 OM.E 20230109-08
Advertisement
Table of Contents
