Table of Contents
Advertisement
③ For manual input, click [POS&TIME], use the numeric keys to enter latitude/longitude of your position, and
UTC time. To change coordinate, click 1 for North or East; 2 for South or West.
After entering each data, click OK.
Note: When the setting of POSITION input type is [MANUAL], and the message "WARNING: Position data is
not updated! " is shown, the Position data was older than 4H. Please update it.
2.8.7 Timeout Setting
This is to set the time out parameters for some operations.
Click [TIMEOUT] in [SYSTEM SETTING]. The following screen appears:
[MENU BACK]:
Back to the upper menu screen automatically.
[TELEPHONE]:
Close the inactive communications for VHF telephone.
[GENERAL DSC]:
Close the inactive communications except the distress call.
[DISTRESS RX]:
Close the inactive communications for the receiving distress call.
Click to select the item and its time interval desired.
[OFF] leaves the menu screen and/or the inactive communications open until you close them manually.
2.8.8 Port Setting
This is to set the baud rate of I/O ports.
Click [PORT] in [SYSTEM SETTING]. The following screen appears. Click [BAM/INS], [GNSS] or [DATA]
until the desired baud rate appears.
NVR-3000 OPERATION MANUAL & INSTALLATION MANUAL
12
NVR-3000 OM.E 20230109-08
Advertisement
Table of Contents
