Table of Contents
Advertisement
With the exception of the AC mains switch, which is located on the rear panel of the power supply unit, all operating
controls are located on the front panel of the CD player.
AC mains switch
The AC mains switch, which turns AC power to the unit on and off, is located on the rear
panel of the CD player or on the rear panel of the power supply unit (if at hand) above the
AC mains terminal. By switching to the ON position the standby transformer is powered up.
POWER switch
The POWER switch (21) switches the CD player on and off, provided the AC mains switch
is in the ON position.
With the POWER switch (21) set to "OFF", all functions of the CD player are powered
down.
Flipping the POWER switch (21) from "OFF" to "STBY", the POWER LED (22) lights up
orange. This shows that the unit is in standby mode.
When the POWER switch is in "STBY" position, the unit can be turned on and off by pushing
up the POWER switch or pushing the POWER button on the BURMESTER remote control
(accessory).
In operating mode (ON) the POWER LED (22) lights up red and all functions of the CD
player are activated.
PLEASE NOTE: Always switch off the 069 with the POWER switch first before bringing the
AC mains switch into OFF position.
INPUT button
Pushing the button INPUT (10) changes sequentially the signal source between the external
inputs RCA1, RCA2, TORX, MMI (optional), ANALOG on the back panel or the internal CD
transport. The selected input is indicated on the display.
If the activated input gets an invalid signal, the display is flashing.
PLAY/PAUSE button
Pushing the button PLAY/PAUSE (18) starts playback of the CD. Playback of the CD can be
interrupted by pushing the button PLAY/PAUSE (18) again.
By pressing the PLAY/PAUSE button for a longer time you can change the sample rate of
the D/A converter between 96 kHz and 192 kHz. If the sample rate is set to 192 kHz, the
AUDIO LED (16) will illuminate.
STOP button
Pressing the button STOP (17) will stop playback of the CD. To restart the CD from the
beginning, press the PLAY/PAUSE button.
SKIP >>| button
By briefly pressing the button SKIP >>| (13) playback is advanced to the beginning of the
following track. By pressing it several times you can skip ahead one step at a time.
SKIP |<< button
By briefly pressing the button SKIP |<< (12) playback is returned to the beginning of the
playing track. By pressing it several times you can skip back step by step.
DISPLAY button
Pushing the button DISPLAY (11) varies the brightness of the alphanumeric display in four
steps between "max. brightness" to "off".
If brightness is selected to "off", the display will light up only when any controls are used to
change settings. After a few seconds it automatically switches off again.
In SETUP mode, display lights up on "max. brightness" permanently.
OPERATING CONTROLS
9
Advertisement
Table of Contents
