Operating Controls And Function Indicators - Burmester 061 Owner's Manual

With the exception of the AC mains switch all operating controls are located on the front panel. To operate the unit it
must be connected to the AC supply.
AC mains switch The AC mains switch (20) which turns AC power to the unit on and off is located on the
rear panel above the AC mains terminal. By switching to the ON position the transformer is
powered up.
POWER switch The POWER switch (15) switches the CD player on and off, provided the AC mains
switch (20) is in the ON position.
With the POWER switch (15) set to "OFF" all functions of the CD player are powered down.
Flipping the POWER switch (15) from "OFF" to "STBY", the POWER LED (16) lights up
orange. This shows that the unit is in standby mode.
When the POWER switch is in "STBY" position the unit can be turned on and off by pushing
up the POWER switch or pushing the POWER button on the BURMESTER remote control
(accessory).
In operating mode (ON) the POWER LED (16) lights up red and all functions of the CD
player are activated.
PLEASE NOTE: Always switch off the 061 with the POWER switch first before bringing the
AC mains switch into OFF position.
INPUT button Pushing the button INPUT (6) changes sequentially the digital signal source between the
external inputs RCA1, RCA2, TORX, MMI (optional) on the back panel or the internal CD
transport. The selected input is indicated by an illuminated INPUT LED (1) on the front
panel of the CD player.
PLAY/PAUSE button Pushing the button PLAY/PAUSE (13) starts playback of the CD. Playback of the CD can
be interrupted by pushing the button PLAY/PAUSE (13) again.
STOP button Pressing the button STOP (12) will stop playback of the CD. To restart the CD from the
beginning, press the PLAY/PAUSE button.
SKIP >>| button By briefly pressing the button SKIP >>| (8) playback is advanced to the beginning of the
following track. By pressing it several times you can skip ahead one step at a time.
SKIP |<< button By briefly pressing the button SKIP |<< (7) playback is returned to the beginning of the
playing track. By pressing it several times you can skip back step by step.
DISPLAY button Pushing the button DISPLAY (14) varies the brightness of the alphanumeric display in four
steps between "max. brightness" to "off".
If brightness is selected to "off", the display will light up only when any controls are used to
change settings. After a few seconds it automatically switches off again.
In SETUP mode display lights up on "max. brightness" permanently.
OPERATING CONTROLS
5