General Instructions - Burmester Reference 069 Owner's Manual

Please read these instructions and the owner´ s manual carefully and keep these instructions safely with the
owner´ s manual of your component.
If you have any questions, we ask you to contact your dealer.
Operating temperature An operating temperature that is too high or too low may cause malfunctioning. We therefore
recommend letting the unit sit for a while after unpacking and before connecting and
operating it.
Setting up When choosing a place for your equipment please observe the following:
- Avoid direct sunlight.
- Do not subject the equipment to excessive heat, cold, humidity or dust.
- Provide adequate air circulation; avoid placing the equipment in enclosures.
- Slots and other openings in the housing are for ventilation. They must not be covered up.
- Please note that the component is not exposed to dripping water or splash water, also don´
t place boxes with liquid in onto your component.
- Open flames like candles should not be placed on top of any electronic unit.
Mains voltage
- Check before operating the unit to see if the mains voltage setting shown on the back
panel below the AC mains input conforms to the voltage of your household power supply.
Any change should only be done by an expert only.
- For AC connection please use only the three-pronged power cable provided.
The grounding pin should not be bypassed under any circumstances. Connect the
component only to a wall outlet with fully functional grounding pin.
Comm. Operation - Before installation switch off all components of a stereo system. Switch them back on only
after making sure that any and all connections have been made correctly and completely.
- Never try to operate the equipment when it has obviously been damaged or if liquid has
gotten into it.
Terminals The pins of the connecting terminals on the back panel should not be touched by fingers
under any circumstances. Static discharges may damage the electronic circuitry inside the
unit.
Interconnects
We supply custom-made balanced as well as unbalanced interconnect cables and speaker
cables of any length to ensure highest-quality signal paths for our components. The
impedance of our cables is ideally matched to all BURMESTER components.
For the cleanest power supply we recommend our triple-shielded power cord BURMESTER-
POWER.
IR receiver The IR receiver receives signals from the BURMESTER remote control and must not be
covered up by objects.
Heat development Be careful when touching the housing – it may get quite warm during operation.
Reset If the unit does not react when pressing the control keys on the front it may be reset to
normal operation by switching it off and back on using the AC mains switch in the back.

GENERAL INSTRUCTIONS

21