Flying A Single Vq Cabinet Using Eyebolts; Vq Flying Bracket (Single Point Hang Flying Bracket) - Tannoy VQ 100 Quick Start Manual

10
VQ Series

Flying A Single VQ Cabinet Using Eyebolts

The simplest method of flying a single VQ cabinet is with a pair of M10 shoulder eyebolts on the top, using a third eyebolt on the rear of the cabinet to tilt the cabinet.
VEB FORGED EYEBOLT
VQ loudspeakers can be flown with high quality VEB M10 eyebolts with collar to BS4278:1984. The loudspeakers are equipped
with internal steel braces, which also double as the flying points, and accept VEB M10 eyebolts.
To install the VEB M10 eyebolts remove the original M10 counter sunk screws from the locations you wish to install the VEB M10
eyebolts. Then replace these counter sunk M10 screws with the VEB M10 eyebolts. The M10 insert on the rear of the cabinet also
accepts a VEB M10 eyebolt and should be used for tilting the loudspeaker to the desired angle.
IMPORTANT: It is imperative for safety reasons that a minimum of two eyebolts linked to two independently fixed straps are used
per cabinet. Never suspend one enclosure from the other using eyebolts.
Never attempt to use formed eyebolts i.e. formed from a steel rod and bent into an eye.
Flying a single VQ cabinet in a landscape orientation using EBS forged Eyebolts

VQ Flying Bracket (Single Point Hang Flying Bracket)

For safe, flexible and simple flying, the VQ Flying bracket is designed to suspend the VQ cabinet from a single pivot point. This allows precise adjustment of aiming
angles with the cabinet in situ. The flown VQ loudspeaker must be provided with an independent, correctly rated and securely attached secondary safety – in addition
to the principle hardware device. This secondary safety must prevent the loudspeaker from dropping more than 150mm (6") should the principle hardware device fail.
Note: All fixings should be thread-locked and torqued to 25 Nm.
The rod end is used in conjunction with the VQ flying bracket. Two types of rod end are available. One is designed to accept ½" UNC threaded rod, and the other accepts
12 mm threaded rod. (Threaded rod supplied by user).
Quick Start Guide
Item No. Description Quantity
1 M10 Plain Washer 3
2 M10 Spring Washer 3
3 Screw M10 x 50mm 3
4 Bracket Flying - VQ 1
Item No. Description Quantity
1 Rod End – VQ _" UNC or 12mm 3
2 Screw M12x45 Cap Head 3
3 M12 Nyloc Nut 3
11