D
OCUMENT
This guide provides a product overview and installation instructions for CAP M2 fiber variants.
Table 1
lists the supported CAP M2 fiber variants.
For information on how to find the minimum software requirements for ERA hardware, refer to
"Hardware to Software Mapping Information" on page
Document Revision History
This is the first release of the CommScope ERA™ CAP M2 Fiber Medium Power Carrier Access Point Installation
Guide.
Document Cautions and Notes
This document may contain any of the following notes, cautions, and warning icons.
The icon to the left is used to indicate a caution or warning. Cautions and warnings indicate operations or
steps that could cause personal injury, induce a safety problem in a managed device, destroy or corrupt
information, or interrupt or stop services.
The icon to the left indicates a caution or warning that pertains to laser equipment.
The icon to the left indicates a caution or warning that pertains to Radio Frequency (RF).
The icon to the left indicates that the hardware is susceptible to Electro-Static Discharge (ESD) damage.
The icon to the left indicates a caution or warning that pertains to an electrical hazard.
The icon to the left indicates a Note. Notes provide information about special circumstances.
M0203AHA_uc
© August 2022 CommScope, Inc.
O
VERVIEW
Table 1. Supported
Part Number
7 85 1 6 71 -1 0 0 1
7 85 1 6 71 -1 0 0 2
7 85 1 6 71 -1 0 0 3
7 85 1 6 71 -1 0 0 4
F in n am e ( aft er th e b a nds ) st an ds fo r F ibe r
CAP M2
Fiber Models
Model Name
C AP M 2 C-B an d F -A C
C AP M 2 C-B an d F -D C
C AP M 2 35 LT/ 35 HT F - AC
C AP M 2 35 LT/ 35 HT F - DC
43.
CommScope ERA
®
CAP M2 with Fiber Interface
Page 1